Controlling And Operating The Lawnmower; Starting The Lawnmower; Application Range For The Lawnmower; Mowing With The Grass Catcher - Fieldmann FZR 4003 BH Manual

EN 10 Before starting the lawnmower | Controlling and operating the lawnmower
IMPORTANT INFORMATION: When not using the lawnmower for longer than 30 days, drain the fuel
tank, start the engine and let it run until the fuel lines and the carburettor are empty (the engine will stop on
its own). This will prevent future engine problems.
Before using it again, add fresh fuel into the fuel tank. For more information, see chapter Storage
instructions.
7. CONTROLLING AND OPERATING THE
LAWNMOWER

STARTING THE LAWNMOWER

1. If the engine is not warmed up, press the fuel primer bulb 2-3 times (Fig. 5 – point 1).
If the engine is already warm, it is not necessary to use the fuel primer bulb.
2. Pull the start/brake lever towards the handle and hold it there (Fig. 5 – point 2), then pull on the pull cord
(Fig. 5 – point 3). The engine should start up after 3-4 pulls.
3. The engine is turned off by releasing the start/brake lever.
Caution! A small amount of smoke may be emitted when the engine is started up for the first time as the
protective layers in the engine are burnt off. This is completely normal and does not constitute a problem.
APPLICATION RANGE FOR THE PETROL LAWNMOWER
Mowing with collection of grass clippings in a grass catcher
Mowing with rear discharge of grass clippings

MOWING WITH THE GRASS CATCHER

When the grass catcher is installed, grass clippings are discharged into the grass catcher

MOWING WITH REAR DISCHARGE

Without the grass catcher installed, the grass catcher cover serves as a deflector that directs the movement of
the grass clippings towards the ground. A row of grass clippings is thereby formed behind the lawnmower
Fig. 5
FZR 4003 BH