Table of Contents
Advertisement
Chapter 1 Overview and Setup
The Laminator is an accessory for the IX-R7000. The Laminator streamlines the printing process by
laminating the cards as they are printed by the IX-R7000.
To use the Laminator, it is required to install a special firmware on the IX-R7000. This firmware
allows for the IX-R7000 to communicate with the Laminator. See Firmware Requirements on page
4 for more information.
Visit the below URL to learn more about the IX-R7000 and to download manuals.
www.usa.canon.com/support/p/ix-r7000-id-card-badge-printer
Firmware Requirements
The special IX-R7000 firmware version v.1.51.F01 is required to communicate with the Laminator.
The firmware can be downloaded from the below URL.
https://downloads.canon.com/hsg2022/IXR7000/IX-R7000_151_F01.npr
Please refer to the IX-R7000 User Manual for firmware update instructions.
Installation
The Laminator must be installed against the left side of the IX-R7000 so that the printer output slot
aligns with the Laminator input slot. The Laminator connects to the IX-R7000 via an RS-232C serial
cable to facilitate communication and error handling. The serial cable must be connected to the
(OPTION) port on the IX-R7000. The Laminator must always be turned on first before turning on
the IX-R7000.
Please view the below instruction video for detailed Laminator installation information.
https://downloads.canon.com/hsg2023/IXR7000/laminatorinst.mp4
4
IX-R7000 Card Lamination Module Configuration Guide
Advertisement
Table of Contents
