Putting Into Operation; Putting The Expert App Into Operation; Connection Between Controller And Remote Control; Connection Of Controller And Expert App - FIOR & GENTZ NEURO TRONIC Instructions For Use Manual

Hide thumbs Also See for NEURO TRONIC:

Table of Contents

12. Putting into Operation

Download the app with your smartphone/tablet. Minimum requirements are Bluetooth 4.0

and Android 6.0 or iOS 10. Unlock the app once from the login area on the FIOR & GENTZ

website. This ensures that patients cannot access the Expert app and change the orthosis'

settings.

In order to connect the remote control to the controller, proceed as follows:

1 Press the MODE button on the controller. First, a short beep is emitted. Press and hold the button until a

second, longer beep is emitted after about 6–10 seconds.

2 Press the Auto and Lock button of the remote control at the same time for about four seconds. The LED

blinks orange.

The orthosis can only be controlled by the one remote control or app to which it is currently connect-

ed. Other remote controls/apps have no influence on the orthosis.

If the connection to the controller has been successful, the LED on the remote control blinks green. If estab-

lishing the connection has failed, it blinks red.

The remote control can also be connected to two controllers:

1 Press the MODE button on both controllers. First, a short beep is emitted. Press and hold the buttons until a

second, longer beep is emitted after about 6–10 seconds.

2 Press the Auto and Lock buttons of the remote control at the same time for about four seconds. The LEDs

light up.

If the connection to both controllers has been successful, the LED on the remote control blinks green twice. If

the LED on the remote control blinks green only once, the remote control is only connected to one controller.

In this case, repeat steps 1–2. If establishing the connection has failed, the LED blinks red.

In order to adjust an orthosis with the app, Bluetooth must be permanently activated and the app must

be opened in the foreground. Use the app menu and select the menu item Pairing. Follow the additional

instructions in the app. The controller cannot communicate simultaneously with multiple Expert apps. If there

is an active connection to the app, the blue LED on the controller will blink permanently. If you want to adjust

the orthosis with the Expert app on a different mobile device, you must first close the app that is currently

connected to the controller.

fig. 31

Table of Contents