Table of Contents
Advertisement
D. Changing Program Settings
1. Choose the program number you wish to edit
2. Press and hold down the Right Arrow key for 3 seconds.
3. You will see the Time / % display begins to flash.
4. Change the settings as indicated in steps E to J.
Important Note: If your machine is equipped with the most recent version of the PNC-01
control you will not need to implement the instructions above in order to change program
settings.
E. Vacuum
1. Make sure the LED above the word VAC is lighted.
2. Using the Plus/Minus keys increase or decrease the vacuum time.
3. Press the Right Arrow key to move to the next setting.
Important note: You may always use the left arrow key to go back to the previous setting.
F. Gas (Optional) See Optional Settings
1. Using the Plus/Minus keys set to 0.00
2. Press the Right Arrow key 3X to move to the next setting.
G. Seal 1
1. Using the Plus/Minus keys increase or decrease the seal time.
2. Press the Right Arrow key to move to the next setting.
H. Seal 2: Not used at this time.
I. Cool
1. Using the Plus/Minus keys increase or decrease the cooling time.
2. Press the Right Arrow key to move to the next setting.
J. Soft Air: This feature allows the chamber to partially vent in short pulses. Three
separate settings are required to complete this operation.
1. The first setting is Total Vent Time. Using the Plus/Minus keys to set the amount of
Total Vent Time you want.
2. Press the Right Arrow key to move to the next setting. You will see that the soft air
LED remains on. However you are now setting the Vent On time.
3. Using the Plus/Minus keys set the amount of time you want the vent valve to open
during each pulse.
11
Advertisement
Table of Contents
