Table of Contents
Advertisement
CLEANING
Before cleaning the appliance, close the gas stopcock and
unplug appliance or disconnect power at the main circuit
breaker of the electrical system.
Do not clean the appliance surfaces when still hot.
Always clean off spillage as quickly as possible to prevent
burning on which will make removal more difficult. Wash with
a clean cloth soaked in hot soapy water, rinse and dry with a
soft cloth.
DO NOT USE ABRASIVES. CAUSTIC PASTES OR SPRAYS.
COARSE CLEANING PADS OR POWDERS. DO NOT USE
EXCESSIVE WATER WHEN CLEANING YOUR OVEN IN
ORDER TO AVOID WATER PRESSING THROUGH CLEFTS
INTO THE BACK OF CONTROLS PANEL OR OF THE UNIT.
NOTE: A steam cleaner is not to be used for cleaning this
appliance.
Pan supports and burners
The burner heads can be removed for cleaning.
NB Do not drop hot burner caps in cold water.
Because of the rapid cooling they might get damaged.
Lift off and soak for about 10 minutes in hot water with a little
detergent. After having cleaned and washed them, dry them
carefully.
Make sure that no burner holes are clogged.
Clean the burners once a week or more frequently if
necessary.
Make sure you have reassembled the burners correctly.
Pan supports can be washed by hand or in a dishwasher.
Remember to remove rubber feet (if fitted) prior to washing.
Refit them afterwards.
Do not use harsh abrasive cleaners or sharp metal scrapers to
clean the oven door glass since they can scratch the surface,
which may result in shattering of the glass.
burner cap
locating pegs
notch for electrode
in burner head
electrode
For a triple crown burner, make sure head "C" and covers "A"
and "B" are properly placed on their seats as figure E and not
off-centered as in figure F
A
B
C
A
B
Fig. E
A
B
Fig. F
Daily
Regular wiping down directly after use prevents dirt from
burning on. Clean the appliance with water and a detergent or
all purpose cleaner.
Avoid using too much water to prevent it entering the burner or
ventilation openings.
You can remove the hook-in racks in order to clean them
separately.
The hook-in racks are all fixed to the walls of the cooking
compartment at four points.
To remove the hook-in racks, proceed as follows: (Fig. G)
1. Undo the screw on the bottom the hooking rack.
The lower hooks of the hook-in rack are released.
2. Take hold of the top of the hook-in rack and screw.
On the screw on the bottom the hook-in rack again.
To reinsert the hook-in racks, proceed as follows: (Fig. H)
1. Insert the upper hooks into the drill holes in the side panel.
2. Pull the hook-in rack slightly downwards and insert the
lower hooks into the drill holes.
Removing the hook-in racks
Fig. G
Oven accessories (shelves, trays etc) should be washed in
mild detergent solution and should not be treated with
abrasives. The oven interior panels should be cleaned with
mild detergent solution, mild cream cleaners or a moist soap
pad.
lnstall shelves by locating them in the horizontal guide rails on
the oven walls.
The raised portion of the shelf is to be facing the rear wall of
the oven.
IMPORTANT
Do not use excessive water when cleaning the oven and avoid
water passing through the fan grill or ducts in the oven back .
Avoid letting grease deposit collect around the upper heating
element: it will cause smoking and may start a fire.
12
Inserting the hook-in rack
Fig. H
Advertisement
Table of Contents
