Table 2: Service Programming Mode Summary, G 118X/G 2170/G 218X; Table 3: Water Hardness Settings, G 118X/G 2170/G 218X - Miele G 1 Series Manual

G 1xxx/G 2xxx
Function
Model setting
Country setting

Table 2: Service Programming Mode Summary, G 118x/G 2170/G 218x

1
If the electronic needs to be replaced during servicing, the following steps must be taken
during programming: In the first step, set the country specification and model, then switch
off the appliance. Repeat access and then set appliance width and height, and the
appropriate supply water hardness.
2
If the dishwasher is connected to an external ion exchanger water softener (i.e. that
needs to be regenerated with salt), the water hardness delivered by the system must be
set. If this value is unknown, set to 8°d (8.6 grains per gallon).
3
Circulation Turbothermic drying (UTT) version 1 (w/condenser), version 2 (w/out condenser).
4
The SER country specification includes the following countries: Portugal, France, the
Netherlands, Belgium and Great Britain.
Save and quit:
Switch off the appliance.
Water Hardness [°d]
8 – 11
12 – 15
16 – 20
21 – 25
26 – 30
31 – 36
37 – 50
51 – 70

Table 3: Water Hardness Settings, G 118x/G 2170/G 218x

1
Standard setting.
Programming
Press the Program button
38x. To make the desired
setting, press and hold the
1
Program button until the
"Intake/Drain" LED lights
up. Then briefly press the
Program button.
Press the Program button
39x. To make the desired
setting, press and hold the
1
Program button until the
"Intake/Drain" LED lights
up. Then briefly press the
Program button.
Water Hardness [gpg]
1 – 4
5 – 7
Display
The "Intake/Drain" LED flashes 3x
slowly and 8x rapidly. "SaniWash"
LED off: Models without drying fan;
"SaniWash" LED flashes: Models
with UTT version 1 or 2.
The "Intake/Drain" LED flashes 3x
slowly and 9x rapidly. The
"SaniWash" LED's flash pattern
indicates which country is set: 1x:
Europe; 2x: Australia; 3x: USA; 4x:
Japan; 5x: Italy/Spain; 6x: Southern
Europe.
1.1 – 4.3
5.4 – 7.5
8.6 – 11.8
12.8 – 16.1
17.1 – 21.4
22.5 – 26.8
27.8 – 32.1
33.2 – 38.5
39.6 – 53.5
54.6 – 74.9
7
Technical Information
3
4
Flash Pattern of
"SaniWash" LED
1x rapidly
2x rapidly
3x rapidly
1
4x rapidly
5x rapidly
6x rapidly
7x rapidly
8x rapidly
9x rapidly
1x slowly