Miele G 1 Series Manual page 40

Technical Information
Options:
Function
Reset
Setting the language
Setting the time of day
Setting the detergent type
Dispensed rinse aid
quantity setting
Setting the intervals for
the filter checks
Adjust Sensor wash
program
Changing the main menu
Save extras
Programming
Select Reset. To restore the
standard settings, select OK.
To return to the main menu,
press Back.
Select Language.
Select a language and
confirm with OK.
Select Time and confirm
with OK. Choose 12 h Clock
or 24 h Clock and confirm
with OK. Then set the time
(seconds, then minutes)
using the cursor buttons and
confirm with OK.
Select Detergent type.
Select a detergent type and
confirm with OK.
Select Rinse aid. Select a
rinse aid quantity with the +,
- buttons and confirm with
OK.
Select Check filters. Select
a wash interval and confirm
with OK.
Select Adjust sensor wash.
Select a setting and confirm
with OK.
Select Change main menu.
Use the cursor buttons to
mark the program that is to
be replaced, then press OK.
Then use the cursor buttons
to select the program that is
to replace the removed
program. After all changes
have been made, confirm
with OK and return to the
main menu.
Select Save extras. Select a
setting and confirm with OK.
40
G 1xxx/G 2xxx
Display
The display reads Reset standard
settings?
The display lists the languages that
can be selected. A language must
be selected in order to return to the
main menu.
Display of both clock formats,
followed by entry request.
The display shows the selection of
available detergent types: Normal
(powder detergent), 2 in 1 and
Combi-tabs.
The display shows the current rinse
aid dispensing quantities: The
dispensed quantity can be set from
0 to 0.2 fl.oz. (0 - 6 mL). Standard
setting: 0.1 fl.oz. (3mL).
The display shows the intervals
available for selection. Range: 30 -
60 wash cycles.
Setting options On and Off
(standard setting). With this
parameter, Sensor wash can be
adjusted for use against stubborn
stains (if overall soiling is
moderate). If this option is selected,
the main wash temperature is
raised to 131°F, resulting in an
extended running time.
The display shows the programs
available. The order of the first
three can be modified. After fixing
and confirming a new order, the list
is shown again.
This function is activated in the
standard settings. In the display,
this is signaled with the message
On. If you do not wish to save,
select Off.