atd models ATD008 Instruction Manual page 2

1. Detach component A and fold along the
crease lines. Then apply glue to the tab and
bond it to the inside of the wall.
2b. Fold component C along the crease lines.
Then apply glue to the tab and bond it to the
inside of the wall.
3. Locate the glazing sheet and cut out one of
the circular windows along with both of the
arched windows. Then glue them into
position.
2a. Detach component C and place it face down
on your work surface. Then locate the tab on
the right hand side, fold it over on itself and
glue.
Apply firm pressure on the tab until the glue
i
has semi-cured to stop it from lifting.
2c. Detach component B (floor) and place it within
component A (this will ensure the height of
the floor is accounted for). Then apply glue to
the unprinted sides of component C and glue
it inside component A, as per the illustration
below.
4. Detach component D and glue it within
component A, ensuring that there is even
spacing left and right of the component and
the top is flush.