Set Directions and Pull-up Mode
Direction specifies the pins' direction, input or output. If a pin is configured as input, Output
field is disabled and pull field is enabled for that pin. Pull field enables or disables the pull-up
for that pin. After setting the configuration, user must click on the "Set" button to configure
pins.
Example below shows the both configurations. GPIO#5 is configured as "Input" and "Pull"
value is on. Output is disabled for this pin. GPIO#4 is configured as "Output" and pull mode is
disabled for that pin.
DE4001_USER MANUAL
Rev. No:0 Rev. Date: 05.08.2023
Figure 28: GPIO control panel
www.deico.com.tr
Sets configuration and
output values
Reads GPIO pins
21 / 31