I²C Slave Operations; Spi Control Panel - DEICO ONYX DE4001 User Manual

I²C Slave Operations
By selecting the "Slave" tab, I²C can be configured as a slave device. Slave address of the Onyx
I²C slave device can be entered into the slave address field.
Slave address
Enables slave
Sets slave response
Figure 20: I²C slave control panel
To enable the slave device, enable button must be clicked. Response of the slave device can
be set after enabling the slave device. Message area is the same as the master panel's
message field.
While the I²C slave is enabled, any incoming data to the device will be written into the
transaction information panel.

SPI Control Panel

If user selects a mode that enables the SPI, SPI control panel will be displayed. Similar to I²C
there are two tabs for master and slave operations.
Figure 21: SPI control panel
DE4001_USER MANUAL
Rev. No:0 Rev. Date: 05.08.2023 www.deico.com.tr 15 / 31