Set Spi Mode - DEICO ONYX DE4001 User Manual

Set SPI Mode

SPI has 4 different modes. These modes can be set by setting the polarity and phase. There
are separate fields for setting the polarity and the phase.
User can select the polarity and phase from the combo boxes. After setting the polarity and
phase, by clicking the "Configure" button, SPI configuration is sent to the device.
Note Application saves the configuration to a settings file, see
Messages" for settings. However, these settings are saved to file only, if user resets
the device or powers off, configuration must be set again to operate at the desired
speed.
Note Set configuration works for master operations only.
DE4001_USER MANUAL
Rev. No:0 Rev. Date: 05.08.2023
Figure 23: SPI master - Configure modes
www.deico.com.tr
"Saved Settings and Log
17 / 31