Advertisement
10
Loosen the 2 set screws. You should
be able to put your downrod into the
yoke.
13
Tighten both yoke set screws evenly
to secure downrod.
16
Hang assembled fan from the mounting bracket installed to ceiling in previous
step. Make sure the fan is hanging straight. Rotate fan until the tab on the Mount-
ing bracket engages the slot on the Downrod Ball. This must be done to prevent
the fan body from rotating when the blades are in motion.
Helpful Hint: It will help to slip downrod ball into mounting bracket by slant-
ing fan assembly and canopy.
© 2011 Monte Carlo Fan Company
11
Place canopy and then yoke cover
over downrod. Then thread the lead
wires and safety cable from fan
through the downrod as shown.
14
Place yoke cover on top of fan hous-
ing.
4
12
Insert downrod into motor yoke. Next,
insert ccross pin through yoke and
downrod and secure with keeper pin.
15
Remove the shipping stabilizer by
removing the set screws and dis-
carding.
17
Re-install safety bar removed in step.
3 by placing safety bar on screws,
sliding into place, and tightening the
2 screws.
12/27/2011
Advertisement
