Adjustment Of Belt Tension; Installation Of Belt Cover - SunStar SC 7200A Series User Manual

3) Adjustment of belt tension

[ Warning ]
Be sure to turn the power switch off before adjusting belt
tension.
Turn the screw④ of the motor③ around. Adjust the belt ①
to go in approximately 10~20mm when its center portion is
pushed with a finger. (Refer to figure 13)

4) Installation of belt cover

[ Warning ]
Always install the belt cover for safety.
Fasten the belt cover (upper)① with a screw② as shown in figure 14. For A-Type table, mount the belt cover (lower)③ as
shown in figure 15.
16
①
②
[ Figure 14 ]
②
10~20mm
④
③
①
[ Figure 13 ]
③
[ Figure 15 ]