Product Information Charging Contact Magnetic Adhesive Head Mount Alignment Charging Magnet Indicator LED Hook Clip Fixing Plate Adjustable Collar Power Input Port...
Page 3
Attaching the mount to the holder 1. Place the adjustable collar over the ball of the mount 2. Press the ball of the mount into the back of the magnetic wireless charging head 3. Move the magnetic wireless charging head to the desired position and tighten the adjustable collar.
Page 4
Attaching the hook mount to a vent 1. Unfasten the hook clip sufficiently by rotating the fixing plate. 2. Insert the hook clip to the center of the vents 3. Rotate the adjustable collar so that the fixing plate tightens against the hook to avoid the presence of any gap between fixing plate and vent.
Charging your device 1. Connect the supplied USB cable to the power input port of the magnetic wireless charging head 2. Connect opposite end of the supplied USB cable into a USB car charger or USB power adapter (Not Included). 3.
Page 7
CAUTION 1. The magnet used in this product will have no negative impact on the phone. In case of any applications not working correctly, please restart application and slightly adjust the position of where smartphone is mounted. 2. Never mount a smartphone onto holder with a magnetic credit card in the smartphone case.
Page 8
NOTE 1. The car charger or adapter used to power the Wireless Charging Magnetic Holder that outputs the proper voltage is required (Not included). 2. The connected power car charger or adapter used must output DC 5V/2A,9V/2A,12V/2A. Using a charger or adapter with a lower output may result in malfunction or overheating.
Wireless charging magnetic head Vent mount Adhesive mount Type C USB charging cable Technical assistance If you need assistance with your Aerpro product call Aerpro Support Australia. TEL: 03 – 8587 8898 FAX: 03 – 8587 8866 Mon-Fri 9am – 5pm AEST This manual is considered correct at time of writing but is subject to change.