Aerpro MagMate Manual

Magnetic suction mount

suction mount

MagMate

APSMSHLD

MAGNETIC SUCTION MOUNT

MANUAL

Table of Contents

Need help?

Do you have a question about the MagMate and is the answer not in the manual?

Page 1 MagMate APSMSHLD MAGNETIC SUCTION MOUNT MANUAL...
Page 2 How to Use Magnetic Holder (Pic1) 1. Put the magnetic plate into the phone case and check the strength of the magnet before attaching the 3M tape. (Pic1) If the phone case is too thick, the magnetic plate can alternatively be placed on outside of the case with the provided 3M tape.
Page 3 (Pic1) Non Slip Suction Mount Arm Magnet Angle Adjuster Magnetic Plate...
Page 4 Suction mount Installation 1. Find the safe and best viewing angle by simply rotating phone at the desired area. 2. Clean any oil, debris, or dust on the area where 3M base is to be placed. If possible use an alcohol wipe to help with suction. 3.
Page 6 Caution 5. Do not install the holder where it will obstruct the drivers view. 7. Periodically check the strength of the suction base. 8. Clean the surface and re-attach if suction strength decreases. 8. Do not operate phone and holder while driving.
Page 7 Technical Assistance If you need assistance setting up or using your Aerpro product now or in the future, call Aerpro Support Australia. TEL: 03 – 8587 8898 FAX: 03 – 8587 8866 Mon-Fri 9am – 5pm AEST Please retain this manual for future reference.
Page 8 Please visit us at www.aerpro.com...

Apsmshld