Table of Contents
Advertisement
Remote engine start
If the system is prepared for remote start, use one of the methods described below to start the
engine, the system will confirm the command with
start engine
1
2
3
armed
Remote Control
• To start the engine, press and hold the
radio coverage zone). In a few seconds the engine will be started.
• To stop the engine, press and hold the
in the radio coverage zone. The engine will be immediately stopped.
Original key
The system reads digital information from a car, this allows you to start and stop the engine by an
original key.
"LOCK"
• To start the engine, press the
button 3 times within 5 seconds (the key must be in the radio coverage
zone.
• To stop the engine, press the
"LOCK"
button 3 times within 5 seconds (the key must be in the radio coverage
zone).
!
r
emoTe engine sTarT by an original key doesn
p
s
.
!
your car in
andora
pecialisT
T
30
he funcTion becomes available only
seconds afTer arming
Phone
To start the engine, call the system number, wait for the answer. Dial the
repeat the
command when the engine is running, it will prolong the operation period by 10
minutes (this procedure can be repeated multiple times).
To stop the engine, call the system number, wait for the answer. Dial the
38
3х
light signalization.
3x
*
engine started
button for 3 seconds (the remote control must be in the
button for 2 seconds or more (the remote control must be
'
. c
T require any addiTional seTTings
heck if The funcTion available for
.
command. If you
command.
PA N D O R A C A M P E R V 3
Online service
• To start the engine, login to the PANDORA-ON.COM (when the system is online there is an Internet
connection), press the START ENGINE button on the control panel. In a few seconds the engine will
be started, it will be confirmed with the spinning
• To stop the engine, press the STOP ENGINE button on the control panel. In a few seconds the engine
prolong engine
will be stopped and the spinning
operation (10 min)
1
2
3
*
Mobile application Pandora Connect
• To start the engine, open the mobile application. When the system is online (there is an Internet
stop engine
or Bluetooth connection) press and hold the START ENGINE
the scale is fully loaded. In a few seconds the engine will be started, it will be confirmed with the
spinning icon
Sending the command again (press the
3
2
1
*
of the remote or automatic engine start by 10 minutes. This procedure can be repeated multiple times.
• To stop the engine, press and hold the STOP ENGINE
is fully loaded. In a few seconds the engine will be stopped and the spinning icon
Engine preheater
Use one of the methods described below for remote start of the engine preheater:
Phone
For remote control of the engine preheater, call the system number, wait for the answer and dial the
command:
•
"Switch on engine preheater";
•
"Switch off engine preheater".
If the control of the preheater operation function is implemented, a voice message «Engine preheater
switched on» will play in the main voice menu for the entire duration of the preheater operation.
Service mode
It is recommended to put the system into the Service mode before handing it to a car service or valet
parking. When this mode is switched on, security system stops interfering with built-in electronics and
disables all functions to ease maintenance.
U S E R M A N UA L
icon will be faded.
.
icon and confirm command) will extend operation period
- to start the engine preheater. The system will confirm command by a voice message
- to stop the engine preheater. The system will confirm command by a voice message
icon.
button on the control panel until
, button on the control panel until the scale
will be faded.
39
Advertisement
Table of Contents
