Table of Contents
Advertisement
Overview
Note
External Flash Storage
Package Contents
The following figure shows the package contents for the Firepower 1100. Note that the contents are subject
to change, and your exact contents might contain additional or fewer items.
Note
For Windows operating systems, you must install a Cisco Windows USB Console Driver on any
PC connected to the console port before using the USB console port. See
Port with Microsoft Windows, on page 29
The chassis contains a standard USB Type A port that you can use to attach an external device. The USB
port can provide output power of 5 volts, up to a maximum of 1 A (5 USB power units).
• External USB drive (optional)—You can use the external USB Type A port to attach a data-storage
device. The external USB drive identifier is disk1. When the chassis is powered on, a connected
USB drive is mounted as disk1 and is available for you to use. Additionally, the file-system
commands that are available to disk0 are also available to disk1, including copy, format, delete,
mkdir, pwd, cd, and so on.
• FAT-32 File System—The Firepower 1100 only supports FAT-32-formatted file systems for the
external USB drive. If you insert an external USB drive that is not in FAT-32 format, the system
mounting process fails, and you receive an error message. You can enter the command format
disk1: to format the partition to FAT-32 and mount the partition to disk1 again; however, data might
be lost.
There are three sets of four screws that you can use to secure the chassis to your rack. Chose the screws
that fit your rack.
for information on installing the driver.
Cisco Firepower 1100 Series Hardware Installation Guide
Package Contents
Connect to the Console
5
Advertisement
Table of Contents
