Hatco HDWTC Series Original Instructions Manual page 7

Installing Anti-Tip Protection
Freestanding units may require anti-tip protection by either
fastening the leg flanges to the floor or installing the Anti-Tip
Wall Bracket supplied with the unit (both available at time of
order from Hatco).
Fastening Leg Flanges to the Floor
1. Make sure the unit is in the desired
location and has been properly leveled.
2. Using the appropriate fasteners, secure
each leg flange to the floor.
Installing the Anti-Tip Wall Bracket
1. Move the unit to the desired location against the wall
where the wall bracket will be installed. Make sure the unit
has been properly leveled.
2. Loosen, but do not remove, the two screws that secure the
anti-tip plate to the top of the unit.
3. Determine the location of the wall bracket on the wall.
a. Position the wall bracket flush against the wall above the
unit.
b. With the locking tab handle pushed down on the
bracket, position the bracket so that the locking tab sits
completely inside the cutout on the anti-tip plate.
• Move the anti-tip plate back-and-forth as necessary
to properly seat the locking tab inside the plate.
Secure the plate to the unit once the proper location
is determined.
c. Mark the locations for the wall bracket fasteners through
the holes on the wall bracket.
HDWTCCEM1-1122
4. Pre-drill the holes in the wall at the marked locations for the
appropriate wall bracket fastening system.
5. Install the wall bracket using the appropriate fasteners.
6. Lift the locking tab handle on the wall bracket, and move
the unit in position underneath the wall bracket.
Leg Flange
7. Release the locking tab handle so that the locking tab sits
completely inside the cutout on the anti-tip plate.
7
INSTALLATION
Locking Tab Handle
Anti-Tip Wall Bracket
Screw
Anti-Tip Plate
(adjustable)
Installing the Anti-Tip Wall Bracket
Locking Tab