Panel standoff rubber
Prerequisite
Before you start, read Chapter 1 "Important safety information" on page 1 and print the following
instructions.
Removal steps
1. Remove the base module. See "Base module" on page 54.
2. Remove the panel standoff rubber.
LCD cover
Prerequisite
Before you start, read Chapter 1 "Important safety information" on page 1 and print the following
instructions.
Removal steps
1. Remove the base module. See "Base module" on page 54.
2. Remove three screws and then remove the LCD cover.
Camera board, camera bracket, camera rubber and camera cable
Prerequisite
Before you start, read Chapter 1 "Important safety information" on page 1 and print the following
instructions.
74
Hardware Maintenance Manual