Answer Machine Settings; Remote Activation - Doro Arc 6 Instructions Manual

Out of memory
�he memory has room for up to 59 messages (including the outgoing message) max. 30 minutes
depending on the compression you set. When
new messages can be recorded until the old ones have been played back and deleted. In that case, the
telephone answer machine responds with the outgoing message for Answer Only.
PLEASE NOTE!
Remember to delete messages regularly!

Answer machine settings

Press . Scroll to
1.
Scroll to
2. TAM SETTINGS
Scroll to desired function. Press
3.
Scroll to desired setting. Press
4.
Choose between
ANSWER MODE
Select language for pre-recorded outgoing message. �o activate this, press
TAM LANGUAGE
button) during playback of outgoing message.
Record/listen to outgoing msg.
OGM SETTINGS
Select after how many rings (2,4,6,8, time saver*) the call will be answered.
ANSWER DELAY
Select maximum recording time for each msg.
RECORD TIME
Select remote access off/on.
REMOTE ACC.
Higher compression gives longer recording time but reduced sound quality, LOW = best
COMPRESSION
sound quality but about half memory capacity.
Enable/disable the function in base unit which is described in chapter Screening.
BS SCREENING
Change remote access code (0000).
CHANGE PIN
The Time Saver function answers calls after six ring signals, until the first new message has been registered
- then the answer machine switches to answering after approximately two signals. This is useful when using
remote access; if you call up the answer machine and there is no reply after four rings that means there are no
messages recorded and you can hang up before you are charged for the call.

Remote activation

�he answer machine can be activated via the remote access functions.
Call the answer machine. It will answer after approximately 10 rings.
1.
Press when the outgoing message is played.
2.
*
Enter the PIN code, see
3.
Press .
4.
7
Replace the handset.
5.
. Press
ANS. MACHINE
. Press .
OK
.
OK
.
OK
ANSWER & REC
Answer machine Settings
English
is shown or the base unit flashes
TAM FULL
.
OK
and
ANSWER ONLY
. One beep confirms correct code.

, no
FF
(caller cannot leave message).
(right menu
C