Answer Machine Settings; Personal Message (Memo) - Doro NeoBio 40 Manual

Using the answer machine (handset)
New message is indicated in the display in standby
mode. Playback always starts with new messages.
1. Press Menu. Scroll to Answer Machine. Press Select.
2. Scroll to Playback. Press Ok.
3. During playback the following commands are available
or press Menu and scroll to the desired function.
4. End by pressing
L
Command Function
2 (X).................Delete during playback
8 8
4 ( ) . ............Previous message
5 (■) .................Stop
9 9
6 ( ) . ............Skip to next message
......................Speaker On/Off
} {
/ . ...............Volume control
Delete all old messages
1. Press Menu. Scroll to Answer Machine. Press Select.
2. Scroll to Delete All. Press Ok.
3. Confirm by pressing Ok.
.
English

Answer Machine Settings

1. Press Menu. Scroll to Answer Machine. Press Select.
2. Scroll to TAM Settings. Press Select.
3. Scroll to desired function. Press Select.
4. Scroll to desired setting. Press Select.
Answer Mode
TAM Language
OGM Settings
Answer Delay
Recording Time
Base Screening
Remote Access
Chg Remote PIN Change remote access code (0000).
*The Time Saver function answers calls after six ring
signals, until the first new message has been registered
- then the answer machine switches to answering after
approximately two signals. This is useful when using remote
access; if you call up the answer machine and there is no reply
after four rings that means there are no messages recorded
and you can hang up before you are charged for the call.

Personal message (Memo)

1. Press Menu. Scroll to Answer Machine. Press
Select.
2. Scroll to Memo. Press Select.
3. After the long beep you can record your message
(speaking approx. 20 cm from the keypad).
4. Press Ok. The message will be played back to you.
5. Memos are played back in the same way as ordinary
incoming messages.

Choose between Answer & Record
and Answer Only (caller cannot
leave a message).
Select language for pre-recorded out-
going message. To activate this function
select Default under OGM Settings.
Record/listen to outgoing msg.
Select after how many rings (2-9, Time
Saver*) the call will be answered.
Select maximum recording time for
each msg.
See separate description of this
function in the base unit.
Select remote access on/off.