Answer Machine Settings; Personal Message (Memo) - Doro NeoBio 10 Manual

Use of answer machine (base unit)
The number in the base units' display will flash when
there are new messages.
and the numbers on the base unit will flash when
there are new messages.
Press (base unit) to start playback.
9
Command Function
8 8 9 9
/ ..........Prev msg/Skip forward.
■ ......................Stop playback.
X ......................Delete current message.
VOL + / - . .........To increase/decrease the volume.
Delete all old messages
After playback: Hold down X until you hear a beep.
Use of answer machine (handset)
New messages are indicated by
in standby mode. Playback always starts with new messages.
1. Press . Scroll to ANS. MACHINE. Press OK.
2. Scroll to MSG PLAYBACK. Press OK.
3. During playback the following commands are available.
4. End by pressing
L
Command Function
2 (X).................Delete during playback
8 8
4 ( ) . ............Previous message
5 (■) .................Stop
9 9
6 ( ) . ............Skip to next message.
......................Speaker Off/On. Only NeoBio 25r.
} {
/ . ...............Volume control
Delete all old messages
1. Press . Scroll to ANS. MACHINE. Press OK.
2. Scroll to DELETE ALL. Press OK.
3. Confirm by pressing OK.
flashing in the display
.
English

Answer machine settings

1. Press . Scroll to ANS. MACHINE. Press OK.
2. Scroll to TAM SETTINGS. Press OK.
3. Scroll to desired function. Press OK.
4. Scroll to desired setting. Press OK.
ANSWER MODE Choose between ANSWER & REC
TAM LANGUAGE Select language for pre-recorded
OGM SETTINGS Record/listen to outgoing msg.
ANSWER DELAY Select after how many rings (2,4,6,8,
RECORD TIME
REMOTE ACC.
COMPRESSION Higher compression gives longer
BS SCREENING This function in base unit is described
CHANGE PIN
The Time Saver function answers calls after six ring signals,
until the first new message has been registered - then the
answer machine switches to answering after approximately two
signals. This is useful when using remote access; if you call up
the answer machine and there is no reply after four rings that
means there are no messages recorded and you can hang up
before you are charged for the call.

Personal message (Memo)

1. Press . Scroll to ANS. MACHINE. Press OK.
2. Scroll to MEMO. Press OK.
3. After the long beep you can record your message
(speaking approx. 20 cm from the keypad).
4. Press OK. The message will be played back to you.
5. Memos are played back in the same way as ordinary
incoming messages.

and ANSWER ONLY (caller cannot
leave message).
outgoing message. To activate this,
press during playback of outgoing
C
message.
time saver*) the call will be answered.
Select maximum recording time for
each msg.
Select remote access off/on.
recording time but reduced sound
quality, LOW = best sound quality but
about half memory capacity.
elsewhere.
Change remote access code (0000).