Alarm Settings; Technical Information - Doro congress 205 Manual

Alarm settings

When the alarm clock is activated  will be displayed in the standby mode.
Once the alarm clock goes off a tone will be heard for one minute, to switch off the
alarm press any button on the telephone.
1. Press and hold
2. Scroll to the required function (off/on/repeat daily) using
cancel the alarm, proceed to point 5.
3. Select the hour (00-23) using
4. Select the minute/s using
5. To cancel the alarm while it is sounding, press

Technical information

Within the battery compartment located on the underside of the telephone you will
find several switches, these switches determine certain technical parameters when
connecting the telephone.
To remove the cover carefully press a small screwdriver (up to Ø 2,5mm) or similar
into the hole to the right of the cover.
Recall time
The recall button timing can be switched between either 100ms (AU/UK/EU)/
300ms (FR/PT)/600ms (NZ), using the R switch located on the underside of the
telephone (within the battery compartment).
Tone/Pulse (Europe only)
Select the required dialling type, Tone (♫) or Pulse (...) using the ♫/... switch located
on the underside of the telephone (within the battery compartment).
Message Waiting indicator
Some PBX systems use a function called Message Waiting. The telephone will indicate
when a call was received by flashing the Massage Waiting light next to the display.
The switch is located behind the battery cover on the underside of the telephone.
The MW function operates differently depending on the PBX in question. Please
contact the system controller for more information.
The following four alternatives are available: LED+, LED-, ringer indicator
( ) and high DC voltage (HV).
When the telephone is used in systems without a telephone exchange (
selected.
until the alarm setting flashes.
v
/
v V
/ . Press
v V
English
. Press .
0
repeatedly to return to standby mode.
0
or lift and replace the handset.
0
7
/ . Press . To
v V 0
) should be