Panasonic GA-MLi8TPoE+ Installation Manual page 14

2 Part Names and Functions
Table1. Ports and Port LED lamps 1 to 10 correspond as shown below.
Port LED
STATUS/ECO
Communication LED
GIGA
(Left)
FULL
LOOP HISTORY
PoE LED
(Right)
14
Display mode Behavior
Green Light
Green Blink
Orange Light
Orange Blink
Off
Green Light
Off
Green Light
Off
Green Light
Off
Green Light
Orange Blink
Off
Communication LED (Left)
LEFT LED（ORANGE）：LOOP DETECTION
1 3 5
2 4 6
PoE LED (Right)
Description
Link is established.
Transmitting and receiving data.
It is shut off via the loop detection
and shutoff function/storm control or
the BPDU guard.
It is sending and receiving just the
control packet.
No device connected or the ECO mode is set.
Link is established at 1000 Mbps.
Link is established at 100 Mbps or
10 Mbps, or no device is connected.
Link is established at full-duplex.
Link is established at half-duplex or
no device is connected.
Loop has been detected within the
last 3 days.
No loop detection history.
PoE are being supplied power.
Single port overload.
Also, an overload of the Ethernet Switch
occurs, and the ports are displayed
which cannot be supplied power.
Power is not being supplied, or the
PoE receiving equipment are not
connected.
Also, it is set in the ECO mode.
9
7
8 10