Dell E31S Series Owner's Manual page 30

Hide thumbs Also See for E31S Series:
Table of Contents

Advertisement

Boot Settings
You can use the Boot Settings screen to set the boot mode to either BIOS or UEFI. It also enables you to specify the boot order.
Related tasks
Boot Settings details
Viewing Boot Settings
Changing the boot order
Related reference
System BIOS
Choosing the system boot mode
Viewing Boot Settings
To view the Boot Settings screen, perform the following steps:
Steps
1. Turn on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
NOTE:
If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
3. On the System Setup Main Menu screen, click System BIOS.
4. On the System BIOS screen, click Boot Settings.
Related tasks
Boot Settings details
Changing the boot order
Related reference
Boot Settings
Choosing the system boot mode
Boot Settings details
About this task
The Boot Settings screen details are explained as follows:
Option
Description
Boot Mode
Enables you to set the boot mode of the system.
If the operating system supports UEFI, you can set this option to UEFI. Setting this field to BIOS allows
compatibility with non-UEFI operating systems. This option is set to BIOS by default.
Boot Sequence
Enables or disables the Boot Sequence Retry feature. If this option is set to Enabled and the system fails to boot,
Retry
the system reattempts the boot sequence after 30 seconds. This option is set to Enabled by default.
Hard-Disk Failover Specifies the hard drive that is booted in the event of a hard drive failure. The devices are selected in the Hard-
Disk Drive Sequence on the Boot Option Setting menu. When this option is set to Disabled, only the first
30
Pre-operating system management applications
CAUTION:
Switching the boot mode may prevent the system from booting if the operating system
is not installed in the same boot mode.
NOTE:
Setting this field to UEFI disables the BIOS Boot Settings menu. Setting this field to BIOS
disables the UEFI Boot Settings menu.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dr6300 system

Table of Contents