Introduction; Planning; Technical Specifications - Q CELLS Q.PEAK DUO ML-G9.4 Installation And Operation Manual

1

INTRODUCTION

Validity
These instructions are only valid for crystalline solar modules from
the company Q CELLS as specified at chapter „2.1 Technical
Specifications". Q CELLS assumes no liability for damage resulting
from failure to observe these instructions.
Ä Please observe the wiring and dimensioning of the system.
The installer of the system is responsible for compliance with all
Ä
necessary safety regulations during set-up and installation.
Q CELLS assumes no liability on the basis of these instructions.
Q CELLS is only liable in the context of contractual agreements
or in the context of accepted guarantees. Q CELLS accepts no
other responsibility for the functionality and safety of the modules.
Ä Please observe the instructions for any other system compo-
nents that may be part of the complete solar power system.
It may be necessary to carry out a structural analysis for the
entire project.
Additional information for the Operator
Ä Please keep this manual for the entire life of the solar power
system.
Ä Please contact your system supplier for information concerning
the formal requirements for solar power systems.
Ä Please be sure to contact the relevant local authorities and
energy providers regarding regulations and permit requirements
prior to installation of the solar power system. Your financial
success depends on the fulfillment of these requirements.
Other applicable documents
In addition to this Manual following technical information are
relevant:
DOCUMENT TYPE
Product data sheet
Packaging and transport information
4 INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.PEAK DUO ML-G9.4 – Q CELLS
2

PLANNING

2.1 TECHNICAL SPECIFICATIONS

For additional information see the relevant datasheet of the module provided at www.q-cells.com.
PRODUCT LINE Q.PEAK DUO ML-G9.4
Type Monocrystalline PERC
Length 1840 mm
Width 1030 mm
Frame height 32 mm
Area 1.90 m²
Weight
19.5 kg
Max. system voltage V 1000 V
SYS
Max. reverse current 20 A
Permissible
–40 °C to +85 °C (–40 °F to +185 °F)
temperature range
Junction box
IP67 with bypass diode
protection class
Connector protection class
IP68
Fire rating based on ANSI / UL 61730 C / Type 2
Max. test load Push / Pull 6,000 Pa / 4,000 Pa
1
Max. design load Push / Pull 1 4,000 Pa / 2,660 Pa
Certificates CE-compliant; IEC 61215:2016; IEC 61730:2016; PV module classification: Class II;
UL 61730
1 Test and design load in accordance with IEC 61215:2016, depending on mounting options (see section „2.3 Mounting Options")
EN
1840 mm
1088 mm
≥1200 mm
4 × Grounding points ø 4.5 mm
Label
≥1200 mm
4 × Mounting slots (DETAIL A)
16 mm
DETAIL A
32 mm
8.5 mm
24.5 mm
Fig. 1:
External dimensions and components for
Q.PEAK DUO ML-G9.4
INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.PEAK DUO ML-G9.4 – Q CELLS
376 mm
Frame
981 mm
1030 mm
8 × Drainage holes
5