Setting Up The Motionskin; Connecting The Powerbox To The Motionskin - EMS EasyMotionSkin Instruction Manual

Hide thumbs Also See for EasyMotionSkin:

Table of Contents

Please select a MotionSkin in the correct size and with an optimal fit. Put

on the dry MotionSkin, initially without the PowerBox. Make sure that the

Setting up the

electrodes fit correctly and securely on the muscles to be stimulated. If the

MotionSkin

fit is too loose or insecure, the electrodes may not connect to the skin or

the electrode connection may break off during training. Depending on the

program setting, this will lead to a loss or reduction of the stimulation of

the respective electrode channel until the connection is correctly re-

established. Your salesperson will advise you on the right size. In case of

doubt, the fit of the MotionSkin can be additionally optimised with the

supplied tightening straps. Overstretching the MotionSkin must be

avoided at all costs and can lead to damage.

The MotionSkin lies directly on the skin, so it is recommended to remove

any jewellery from the affected areas beforehand. It should be ensured

that the zipper is completely open. Putting on the MotionSkin can be made

much easier by folding the sleeves and legs of the MotionSkin outwards

(electrodes pointing out-wards). First, the legs should be pulled upwards

piece by piece. Then they can be folded down again (now the electrodes

are in contact with the skin). The buttocks electrodes should be positioned

as far up as possible. If the positioning of the lower part of the MotionSkin

fits, the arms can be put into the sleeves of the MotionSkin. Finally, the

zipper should be closed and the sleeves folded back over (now the

electrodes are in contact with the skin).

If necessary, check the fit of various sizes of MotionSkin and select the

most suitable MotionSkin for the user. If in doubt, the fit of the MotionSkin

can be additionally optimized with the supplied tension straps.

Connect the PowerBox with the MotionSkin The

push buttons on the MotionSkin should be

Connecting the

connected with their counterparts (paddles) on

PowerBox to the

the PowerBox as depicted.

MotionSkin

During training, the PowerBox should be kept in

the pocket provided on the MotionSkin. Ensure

the PowerBox is held securely and firmly to

make sure it does not fall out accidentally.

Table of Contents