Page 1
SOUS-CHEF TODDLER TOWER ASSEMBLY & SAFETY GUIDE Make the World Accessible...
Page 2
We’re Here to Help Please reach out to our support team if you need any assistance along the way! M-F 8-4 MST +1 (833) 530-0033 support@sprout-kids.com Assembly Instructions Assembly Video Assembly Video Enjoy the best assembly experience sprout-kids.com/TODT Included Parts...
Page 3
Recommended A rubber mallet or a hammer used with a cu ing board can help align pieces. Rubber Mallet Hammer with scrap wood (not included) or cutting board (not included) Begin Assembly Place Left Side on carpeted floor with slots facing up. Place tabs of Back C into corresponding slots and your weight to pop tabs into place.
Page 4
Spread sides apart to insert tabs on Platform D into slots at desired height. on Back C Push sides together to catch tabs on Platform D in slots on sides. 28”-32” Child 32”-38” Child 38”-44” Child These are general recommendations. Observe how your child uses their tower and adjust the height to meet their needs.
Page 5
Doing one side at a time, slowly step on Ladder E to lock it Ladder should be almost flush with floor when into place. fully locked. NOT LOCKED LOCKED Insert Guard Plate H for children under 32” tall. Then Twist Dowel while slide Dowel G into hole from side.
Page 6
For Disassembly Twist while pulling up on Dowel G to pop it out of place. Slide Dowel G out of holes to remove. Flex Sides A & B apart slightly to remove Guardplate H . TWIST WHILE PULLING UP Turn the Tower upside down. Push down on the frame of Ladder E to release it.
Page 7
Safety Information The Toddler Tower has been designed and refined to maximize safety. Below are some safety tips and recommendations you should consider: Children should never use the tower without adult supervision. This will enable you to step in if your child is misusing the Toddler Tower. Do not allow children to climb on the sides, intentionally rock the tower, or climb up through the top onto other surfaces.
Page 8
2023 QUARK ENTERPRISES. LLC PO BOX 1123, PROVO, UT 84601 DOCUMENT: AI-TODT...
Need help?
Do you have a question about the SOUS-CHEF and is the answer not in the manual?
Questions and answers