Installing The Camera; Removing The Infrared Camera - Dell P138G Service Manual

3. Carefully pry and lift the camera module from the display back cover.

Installing the camera

Prerequisites
NOTE: The camera installation procedure is applicable only for Latitude 5330 laptop and not for the 2-in-1 configuration.
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the camera and provides a visual representation of the installation procedure.
Steps
1. Insert the camera into the slot on the display back cover.
2. Connect the camera cable to the connector and adhere the adhesive tape above the camera connector.
Next steps
1. Install the display panel.
2. Install the display hinges.
3. Install the display bezel.
4. Install the display assembly.
5. Install the 3-cell battery
6. Install the base cover.
7. Follow the procedure in

Removing the infrared camera

Prerequisites
NOTE: The infrared camera removal procedure is applicable only for Latitude 5330 laptop and not for the 2-in-1
configuration.
1. Follow the procedure in
2. Remove the base cover.
3. Remove the 3-cell battery
100 Removing and installing components
or 4-cell battery.
after working inside your
before working inside your
or 4-cell battery.
computer.
computer.