Handset Registration - Snom M55 Quick Installation Manual

Handset Registration

The handset must be registered to the base station in order to make and
receive calls. When you power up the handset for the first time, it will attempt
to auto-register to the base station. Auto-registration will be successful only
if you have set up the M500 configuration file with the handset IPEI, or you
have entered the IPEI on the Primary base station's WebUI.
Auto-registering the handset to the base station
1. Make sure the base station is connected to power and the network.
2. If the handset is displaying the following screen:
3. If the handset is displaying the following screen:
If registration is successful:
The handset beeps and displays "Handset registered",
and then displays the idle screen.
If registration fails:
The handset displays "Registration failed".
a. Press OK.
The handset displays "Device not registered to base station."
b. Press IPEI to display the handset's IPEI and
serial number. Give these numbers to your phone
administrator.
c. Press Back.
d. To manually register your handset, follow the steps
in "Manually registering via the LINK key on base
a. Wait for the handset to auto-register.
b. If the IPEI has not been set up in the configuration file
(provisioned), or the auto-registration is taking too
long, press Cancel.
a. Press Reg.
The handset displays the "Register via" menu.
b. Press or
press Sel.
c. Wait for the handset to auto-register.
d. If auto-registration is taking too long, press Cancel.
to scroll to Auto reg or IPEI input, and
20