Snom M55 Quick Installation Manual page 19

Wall mounting the charger
The charger is ready for tabletop use. If you want to mount the charger on a
wall, use two 10 mm (3/8 inch) screws and wall anchors to hold the charger
in place. Screws and wall anchors are not provided, but are available for
purchase at hardware retailers. You might need a professional to install the
charger.
To mount the charger on the wall:
1. Use a pencil to mark the desired positions of the two holes on the wall.
Make sure the space between the two holes is 30 mm (1 3/16 inches).
Drill two holes in the wall according to the marks.
2. If you drill the holes into a stud, go to step 3.
-OR-
If you drill the holes into an object other than
a stud, insert the wall anchors into the holes
and tap gently on the ends with a hammer
until the wall anchors are flush with the wall.
3. Insert the screws into the holes and tighten
them until only 6 mm (1/4 inch) of the
screws are exposed.
4. Align the holes at the back of the charger
with the screws on the wall and slide the
charger down until it locks into place.
Mount the device
only at heights not
exceeding 2 meters.
19