Usb Console Led; S-Pwr Led - Cisco Catalyst C3850 Series Hardware Installation Manual

Product Overview
Port Mode
PoE+
10

USB Console LED

The USB console LED shows whether there is an active USB connection to the port.
Table 7: USB Console LED
LED
USB console port

S-PWR LED

Table 8: S-PWR LED
Color
Off
Green
OL-26779-05
Port LED Color
10
Off
Green
Alternating green-amber
Blinking amber
Amber
Only switches with PoE or PoE+ ports.
Description
StackPower cable is not connected, or the switch is in standalone mode.
Each StackPower port is connected to another switch.
Meaning
PoE+ is off.
If the powered device is receiving power from an AC
power source, the port LED is off even if the device is
connected to the switch port.
PoE+ is on. The port LED is green when the switch port
is providing power.
PoE+ is denied because providing power to the powered
device will exceed the switch power capacity.
PoE+ is off due to a fault or because it has exceeded a
limit set in the switch software.
PoE+ faults occur when noncompliant cabling
Caution
or powered devices are connected to a PoE+
port. Use only standard-compliant cabling to
connect Cisco prestandard IP Phones and
wireless access points or IEEE
802.3af-compliant devices to PoE+ ports. You
must remove from the network any cable or
device that causes a PoE+ fault.
PoE+ for the port has been disabled.
PoE+ is enabled by default.
Note
Color
Green
Off
Catalyst 3850 Switch Hardware Installation Guide
USB Console LED
Description
USB console port is active.
The USB is disabled.
19