Installation; To Mount The Product; To Mount With Mounting Holes; To Mount With Hanger Bar And Mounting Holes - SystemAir fantech bathfan Simple SMPL Series Installation, Operation And Maintenance Instructions

3

Installation

3.1

To Mount the Product

Note:
Before this product is mounted, and if applicable, Fantech
recommends to install a Ceiling Radiation Damper (#98599)
to this product. To see how to install a radiation damper to
this product, refer to section
Damper.
Note:
This product is designed for installation in ceilings up to a 12/
12 pitch (45 degree angle).
Note:
This product is type IC (Inherently Protected).
Note:
To make sure the product can be set correctly anywhere be-
tween the framing, hanger bars have been supplied.
Note:
The hanger bars can be used on all types of framing, such
as: I-joists, standard joists, and truss construction.
1 Before installation, remove the product from the packaging
and set the packaging aside.
2 Identify the locations of Hole A & Hole B, and the channel
on the side of the product's casing.
A
1
2
1. Hole B
2. Hole A
3. Casing Channel
3.2

To Mount with Mounting Holes

1 Align the product as necessary to mount the product be-
tween the framing.
2 Using (4) B screws, install the product onto the framing
through Holes A & B.
3.9 To Mount the Radiation
1
2
3
1
1
1. B Screw
3.3 To Mount with Hanger Bar and
Mounting Holes
1 Engage (1) hanger bar with the channel on the product's
casing.
2 Adjust hanger bar as necessary to mount the product be-
tween the framing.
3 Align the hanger bar tab with the inner side of the framing.
4 Using (2) B Screws, install the product onto the framing
through Holes A & B.
5 Using (1) B screw, attach the end tab of the hanger bar to
the framing.
6 Using (1) A screw, attach the hanger bar onto the product's
casing.
2
3
1
1. B Screw
2. A Screw
3. Hanger Bar
3.4 To Mount to One Side of the
Framing
1 Engage (1) hanger bar with the appropriate channel on the
product's casing.
2 Adjust hanger bar as necessary to mount the product be-
tween the framing.
3 Align the hanger bar tab with the inner side of the framing.
4 Using (2) B Screws, install the product onto the framing
through Holes A & B.
1
2
1
2a
3