Download Print this page

Samsung DW60M5044 Series User Manual page 17

Advertisement

Available languages

Available languages

How to set the softener level
The dishwasher is designed to allow for adjusting the amount of salt consumed based on
the hardness of the water used. This is intended to optimise and customise the level of salt
consumption so that the salt consumption could be set proceed as follows:
The buttons used to enter the setting mode may vary depending on the model.
Check the buttons for your model.
DW60M5050BB : A (Express)
DW60M5062F* / DW60M5052F* / DW60M5042F* / DW60M5044F* : A (Program)
1. Press the A button for fi ve seconds to select the water hardness level setting menu.
-
The display shows the current setting.
2. Press the A button to change the setting.
-
You can select from H1-H6 (soft-hard)
3. Wait 5 seconds to save the setting.
LOADING THE SALT INTO THE SOFTENER
Always use salt intended for use with dishwasher.
The salt container is located beneath the lower rack and should be filled as follows:
ATTENTION
Only use salt specifically designed for use in dishwashers. All other types of salt not specifically
designed for use in a dishwasher, especially table salt, will damage the water softener. In case of
damages caused by the use of unsuitable salt the manufacturer does not give any warranty nor is
liable for any caused damages.
Only fill with salt just before starting one of the complete washing programs. This will prevent any
grains of salt or salty water, which may have been split, remaining of the bottom of the machine for
any period of time, which may cause corrosion.
After the first wash cycle the control panel light expires.
1. Remove the lower basket and then unscrew and remove the cap from
the salt container.
2. If you are fi lling the container for the fi rst time, fi ll 2/3 of its volume with water (around 1 liter).
3. Place the end of the funnel (supplied) into the hole and introduce about
1.5 kg of salt. It is normal for a small amount of water to come out of
the salt container.
4. Carefully screw the cap back on.
5. Usually, the salt warning light will be off after the salt container is fi lled with salt.
DW5500MM_DD81-02615C-10_EN.indd 17
DW5500MM_DD81-02615C-10_EN.indd 17
Open
Open
Using the detergent and water softener _17
2022-12-19 오후 1:50:30
2022-12-19 오후 1:50:30

Advertisement

loading