Advertisement
Mounting set
INFM7002, INFM7102, INFM7202
__________________________________________________________________________________
Alt.2
Using the adjustment tool that is included in the
delivery of Infinity (not this mounting set), set
the angle of the adaptorbar. Only mount the
inner pipe on one side and then rotate the
center pipe to the correct angle. Now mount the
other inne pipe in the same position/angle as
the first one. Check that the center pipe is
centered in the wheelchair. Now tighten the
screws in the clamps (C).
WARNING!
The screws holding the clamps (C)
shall be tightened to 7-9Nm of torque.
Now read the assembly instructions that was included in the delivery of the Infinity unit.
Assemble and adjust the Infinity according to the instruction.
INFO
Don't forget to reassemble the brakes of the wheelchair in case these were removed when
mounting the adaptor. Also, if the seat cloth was loosened during mounting of the adaptor
don't forget to reassemble this.
__________________________________________________________________________________
Page 7/8
Advertisement
