Advertisement
Mounting set
INFM7002, INFM7102, INFM7202
__________________________________________________________________________________
Now use the leveling tool that is included in the
delivery of Infinity. Since the adapter bar have splines
inside it will not be possible to get the bubble of the
spirit level exactly right. Just choose the most correct
position.
The leveling tool has two marks "H" and "L". When the
bubble of the spirit level is towards the "H" the castors
of the wheelchair will lift higher from the ground
compared to if the bubble of the spirit level is towards
the "L".
Adjustment of the angle can be done in two different manners. Both is descriped bellow.
Alt.1
Using the adjustment tool that is
included in the delivery of Infinity (not
this mounting set), set the angle of
the adaptorbar so that the spirit level
is in level. Inside the pipes there are
splines so when rotating you will feel
and hear a clicking. When desired
angle have been accomplished, check
that the center pipe is centered in the
wheelchair. Now tighten the screws in
the clamps (C).
WARNING!
The screws holding the clamps (C)
shall be tightened to 7-9Nm of torque.
__________________________________________________________________________________
Page 6/8
Advertisement
