Download Print this page

Ikegami HLM-5013WR Operating Instructions Manual page 21

2u 5 inches triple lcd monitor

Advertisement

WARNING
Precautions Upon Use
In order to use the monitor safely, read through this
manual and pay attention to the following points in
particular.
1. Do not use any power supply other than the
specified one (AC/DC).
2. Do not give a shock to the monitor.
Be very careful to keep the monitor from shocks
because glass is used inside the LCD.
3. Do not use or store the monitor in the following
places.
Place where the ambient temperature is out of spec
When installing the monitor on a monitor shelf,
switcher table, rack, etc., make sure in advance that
the temperature of the installation location is within
the specified range.
In the case of an outdoor setup, even if the ambient
temperature is within the specified range, the inside
of the monitor may be heated by direct sunlight.
Therefore, keep radiation in mind.
(Avoid direct sunlight.)
Never block the air outlet at the rear of the monitor
and the air inlet at the side. Make sure in particular
that a blackout curtain or the like does not block the
air outlet.
Place exposed to rain, snow or high humidity
Use of the monitor in such a place will cause electric
leakage or failure.
4. Avoid exposing the LCD screen to direct sunlight.
Exposure of the LCD screen to direct sunlight for a
long time will degrade the film. Therefore be careful
of direct sunlight when using the monitor outdoors.
5. Cautions in handling the front protective panel
Be careful not to touch the LCD panel front surface
with bare hands, unless necessary. When wiping the
dust off the surface, use soft, dry cloth and take care
not to rub the surface strongly.
Do not use thinner or benzene.
6. Do not touch liquid crystal leaked from the
monitor's display surface.
If the monitor's display surface is accidentally
broken and the liquid crystal leaks, be careful never
to put the liquid in your mouth, inhale it and allow
it on your skin. If the liquid gets into your eye or
mouth, immediately rinse it with water and get
medical attention.
If the liquid contacts your skin or clothes,
immediately wipe it off using alcohol or the like and
wash the stained spot with soap and water. Do not
leave the liquid intact, because otherwise your skin
or clothes may be affected.
7. Do not display the same pattern for a long time.
Note that residual image may be generated if the
same pattern is displayed for a long time.
Turn off the power when the monitor is not used.
To avoid residual images, preferably take the
following measures.
Change the screen regularly.
Display the whole screen in white.
8. Avoid operation at low temperatures.
Note that the backlight function will be degraded
at low temperatures, leading to shorter service life.
It is recommended to use the monitor at normal
temperatures.
9. Cautions in using the battery
In order to prevent the battery from being damaged
due to over discharge, avoid leaving the monitor
with the battery set in it for a long time.
10. Avoid operation or storage in a place exposed to
corrosive gas.
Operation or storage in a place where any corrosive
gas such as sulfur dioxide, hydrogen sulfide, chlorine
or ammonia is generated may lead to a significant
reduction in the monitor service life.
It may also cause failure or electric leakage.
Also avoid using the monitor in a loca
11. Do not use this monitor for such applications
as space appliance, nuclear control system
as any medical equipment involving human life.

Advertisement

loading