Table of Contents
Advertisement
12.9
Adjusting the basic position of the foot brake lever
Warning
Danger of accidents The brake system fails in the event of overheating.
If there is no free travel on the foot brake lever, pressure builds up in the brake system on the rear brake.
–
Set the free travel on the foot brake lever in accordance with the specification.
12.10
Checking the rear brake fluid level
Warning
Danger of accidents An insufficient brake fluid level will cause the brake system to fail.
If the brake fluid level drops below the specified marking or the specified value, the brake system is leaking or the
brake linings are worn down.
–
Check the brake system and do not continue riding until the problem is eliminated. (Your authorized GAS-
GAS Motorcycles workshop will be glad to help.)
Warning
Danger of accidents Old brake fluid reduces the braking effect.
–
Make sure that brake fluid for the front and rear brake is changed in accordance with the service schedule.
(Your authorized GASGAS Motorcycles workshop will be glad to help.)
–
1
Detach spring
–
4
Loosen nut
maximum free travel.
–
To adjust the basic position of the foot brake lever to individual
requirements, loosen nut
Info
The range of adjustment is limited.
–
5
Turn push rod
essary, adjust the basic position of the foot brake lever.
Guideline
Free travel at foot brake lever
–
5
Hold push rod
Guideline
Remaining nuts, chas-
sis
–
3
Hold screw
A00831-10
Guideline
Nut, foot brake lever
stop
–
1
Attach spring
Preparatory work
–
Check the brake linings of the rear brake. (
.
5
and, with push rod
, turn it back until you have
2
3
and turn screw
accordingly until you have free travel
3 ... 5 mm (0.12 ... 0.2 in)
4
and tighten nut
.
M6
10 Nm (7.4 lbf ft)
2
and tighten nut
.
M8
20 Nm (14.8 lbf ft)
.
p. 85)
BRAKE SYSTEM 12
accordingly.
A
. If nec-
83
Advertisement
Table of Contents
