EIM Lab-OnThe-Go Manual page 50

LOTG Lab-On-The-Go Manual
Automatic Power Off (APO)
By default setting, VEGO will trigger APO after 15 minutes of inactivity (the
built-in buzzer will sound 5 times one minute before shutdown).
To resume the setting from APO, press SEL button so VEGO will resume
back .
To disable APO, press and hold the SEL button first and then turn ON the
device. The buzzer will sound 3 times to indicate the deactivation of APO.
Other Accessories
Attention
• Except ofr battery and fuse replacement, DO NOT attempt ot repair
the meter or change inner circuit, please contact our technical support
directly
• This product should NOT be stored or used under high temperature,
high humidity, flammable, explosive and strong magnetic environments
• Clean the case with a damp cloth and a mild detergent. DO NOT use
corrosives or solvents.
• Turn OFF the meter before cleaning
• Remove the battery if you don't use the device for long time
• When the display shows "
following steps.
a. Unscrew the battery lid at the back
b. Remove all batteries inside
c. Replace new batteries of the same type
d. Install the battery lid and fasten the screws
e. Dispose the old batteries to proper recycle centers
48
" symbol, replace the batteries under the