Page 1
Rack Adapter Panel GRA-418 Assembly Manual GW INSTEK PART NO. 82RA-41800M01 This assembly manual contains proprietary information, which is protected by copyrights. All rights are reserved. No part of this manual may be photocopied, reproduced or translated to another language without prior written consent of Good Will company.
Page 2
The GRA-418 supports both the EIA (GRA-418-E) and JIS (GRA-418-J) standards for use with standard sized rack units. Incorporating a strong frame and robust design, the GRA-418 can fit between 1 ~ 2 PSB-1000 units. Rack Mount Adapter Component List and Assembly...
Assembly 593B-03005NS1 FMS 3*5 62RA-410HP4A1 LEFT BRACKET 62RA-410HP3A1 REAR BRACKET 599B-03006NS1 IMS 3*6 62RA-410HP9A1 RACK HP 594B-W3008NS1 BMS-W3*8 62RA-414HP301 TOP BRACKET 5320-00403001 Pin(SR-3S) Assembly Initial setup 1. Remove the handle (from) the unit. Remove the handle cover. Remove the screws securing the handle to the case.
Page 5
GRA-418 Assembly Manual Instrument 1. Ensure the Middle Bracket is latched onto the catch on insertion the underside of the unit. Unit catch Middle Bracket 2. Attach the Front Bracket to the Middle Bracket with the rack screws. Unit rack...
Page 6
Appearance 2. Secure the panels with the PMS-W-3*8 screw. On the JIS model, use the SR-3S pin to hold the plate to the top bracket. EIA: Blank panel screw JIS: SR-3S Blank panel screw Appearance GRA-418-E...
Page 8
Specification The angle brackets are used to support the bottom of the rack. Note: If using the angle brackets, please pay attention to the size limitations.