Page 1
Rack Adapter Panel GRA-419 Assembly Manual GW INSTEK PART NO. 82RA-41900MA1 This assembly manual contains proprietary information, which is protected by copyrights. All rights are reserved. No part of this manual may be photocopied, reproduced or translated to another language without prior written consent of Good Will company.
Page 2
GRA-419 Assembly Manual GRA-419 The GRA-419 rack mount is suited for the PCS-1000/I Precision Current Shunt. The GRA-419 supports both the EIA (GRA-419-E) and JIS (GRA-419-J) standards for use with standard sized rack units. Incorporating a strong frame and robust design, the GRA-419 can fit between 1 ~ 2 PCS-1000/I units.
Assembly Assembly Initial setup 1. Remove the handle (from) the unit. Remove the handle cover. Remove the screws securing the handle to the case. Remove the handle. 2. Remove the feet from the underside of the unit. Instrument 1.
Page 5
GRA-419 Assembly Manual 2. Attach the Front Bracket to the Middle Bracket with the rack screws. Unit Front Bracket rack screw 3. Secure the Rack Holding Plates (Rack HP) to the groove on the Rear Bracket and to the instrument(s).
Page 6
Appearance 2. Secure the panels with the PMS-W-3*8 screw. On the JIS model, use the SR-3S pin to hold the plate to the top bracket. EIA: Blank panel screw JIS: SR-3S Blank panel screw Appearance GRA-419-E...
GRA-419 Assembly Manual GRA-419-J Specification Load Capacity Max 20kg Rack installation Diagram The angle brackets are used to support the bottom of the rack. Note: If using the angle brackets, please pay attention to the size limitations.