Table of Contents
Advertisement
Use the instructions shipped with the option to help you make the connection and install any software
or device drivers that are required for the option.
Replacing the computer stand
Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page iii.
To replace the computer stand, refer to the following topics:
•
"Replacing the full-function monitor stand (for M700z)" on page 60
•
"Replacing the tilt-only monitor stand" on page 62
•
"Replacing the UltraFlex II Stand (for M800z)" on page 63
Replacing the full-function monitor stand (for M700z)
To replace the full-function monitor stand, do the following:
1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the computer cover is facing up.
3. Press the retaining latch
remove full-function monitor stand from the computer.
Figure 18. Removing the full-function monitor stand
60
ThinkCentre M700z and M800z User Guide
1
on the full-function monitor stand as shown to disengage the latch. Then,
Hide quick links:
Advertisement
Table of Contents
