Motorola L6Q Installation Manual page 40

MN010089A01-AB
Chapter 2 : Pre-Installation
2.8
Pairing Cameras to Mobile Companion
To perform the installation process, cameras must be paired to the Mobile Companion application.
Pairing the camera during pre-installation enables installers to check that the camera is functioning
properly in the Camera Details screen before attempting installation.
Prerequisites: The following must be true of the mobile phone:
• Bluetooth is enabled
• Wi-Fi is enabled
• Mobile Companion is logged on with an Agency Manager or Site Manager account
Procedure:
1 Tap the Cameras icon.
2 Tap the Ellipsis icon at the top of the Cameras screen.
3 Tap Add Camera in the pop-up menu.
4 Tap Start Installation in the Install a new camera screen.
5 Select the server endpoint that this camera will send detection data to in the Select Endpoint
screen.
• To use a VehicleManager Agency, tap LEARN-NVLS.
• To use a ClientPortal Site, tap Client Portal.
• To use the hosted Florida LEARN server Agency, tap LEARN Florida.
• To use a private server, tap Private Server and enter the Server web address and API
Key.
• To use a server that requires Agency Permission to send data to, tap Other.
Most accounts use LEARN-NVLS or Client Portal
6 Activate pairing mode on the camera.
a Press and hold the Power Button for one second.
a Wait a few moments for pairing mode to activate.
When pairing mode is active the LED Status Indicator will blink, alternating between amber
and green.
NOTE: The first press may only wake the camera. If pairing mode does not activate,
wait a few moments and try again.
7 Tap Next in the Power On Camera screen.
8 Select one of the following pairing options in the Pair Camera screen:
40