Motorola L6Q Installation Manual page 36

MN010089A01-AB
Chapter 2 : Pre-Installation
2.6
Installing the Camera Batteries
The camera is powered by two internal Camera Batteries that are inserted into the Battery Tray.
If needed, the individual batteries or the whole Battery Tray can be swapped out before or after
installation. Install the Camera Batteries before attempting to power the camera from one of the
available power options.
Prerequisites: Obtain:
• L6Q Camera
• Camera Batteries
• Battery Tray
• Pin and Torx Tool
Procedure:
1 Ensure that the camera is disconnected from any external power source.
NOTE: Connecting power to the camera before installing the Camera Batteries will
prevent them from charging.
2 Remove and discard any foam or shipping material from between the battery slots in the battery
tray.
3 Install the Camera Batteries into the battery tray:
a Orient one of the Camera Batteries so that the gold contacts are facing up and towards the
center of the Battery Tray.
b Slide the battery into one of the Battery Tray slots.
c Repeat for the other Camera Battery.
When the Camera Batteries are properly installed, the gold contacts will be facing each
other.
4 Install the Battery Tray into the camera:
a Extend the security screws on the Battery Tray.
b Hold the camera in the upright position.
c Orient the Battery Tray with the arrow facing towards the front of the camera.
The front of the camera is the side with the camera lens, opposite the mounting ball.
d Slide the Battery Tray into the battery compartment.
CAUTION: If the battery tray is backwards, it will not slide into the compartment. Do
not force the Battery Tray into the battery compartment.
e Press firmly on the battery tray to seat it into the camera.
f Check that the battery tray is flush with the camera housing.
This will ensure that the camera is resistant to dust and water ingress.
g Tightly secure the two security screws with the Pin and Torx Tool.
36