How To Wire Your Ceiling Fan - Fanimation Benito FP8003 220 Series Owner's Manual

Hide thumbs

Table of Contents

Available languages

How to Hang Your Ceiling Fan (continued)

2. Carefully lift the fan and seat the downrod/hanger

ball assembly on the hanger bracket that was just

attached to the outlet box. Be sure the groove in

the ball is lined up with tab on the hanger bracket

(Figure 3).

Failure to seat tab in groove could cause damage to

electrical wires and possible shock or fire hazard.

To avoid possible shock, do not pinch wires between

the hanger ball assembly and the hanger bracket.

If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a

licensed electrician.

To avoid possible electrical shock, be sure electricity

is turned off at the main fuse box before hanging

(Figure 1).

NOTE: If you are not sure if the outlet box is

grounded, contact a licensed electrician for advice, as

it must be grounded for safe operation.

1. Slide the receiver unit into the open end of the

hanger bracket (Figure 2).

2. Connect wires to terminal block as indicated:

Green hanger bracket and banger ball wires to

green/yellow (earth) wire. Brown receiver unit wire

(AC IN L) to red/brown live supply wire. Blue

receiver unit wire (AC IN N) to blue/black neutral

supply wire. Orange receiver unit wire (AC IN L1)

to orange for light.

Position all connected wires and receiver antenna

to allow installation of ceiling canopy. Using

canopy screws threaded into the hanger bracket

reinstal ceiling canopy. Restore electrical power

(Figure 3)

WARNING