Stihl 410 C-M Instruction Manual page 36

English
3
2
Remove the screw (3) from the
N
shutter.
Pull the shutter (2) out of the
N
shroud.
Rotate the shutter (2) from the
N
summer position to the winter
position and refit it.
Secure the shutter in position with
N
the screw (3).
At temperatures between +10°C and
+20°C
The machine can normally be operated
in this temperature range with the
shutter (2) in the summer position.
Change the position of the shutter if
necessary.
34
At temperatures above +20°C
2
Always return the shutter (2) to the
N
summer position.
NOTICE
Do not operate the machine in the winter
position at temperatures above +20°C
because there is otherwise a risk of
engine running problems and
overheating.
At temperatures below -10°C
In extreme wintry conditions
Temperatures below -10°C
–
Powder or drifting snow
–
it is advisable to use the optional "cover
plate kit".
FS 360, 410, 460
5
FS 490
5
The cover plate kit contains the following
parts for converting the power tool:
4 Cover plate partially blanks off the
slots in the starter housing
5 Air filter with synthetic fabric
element
For FS 460 with tank cap with
–
hinged grip: O-ring for the tank filler
cap
Instruction sheet describing the
–
conversion.
After installing the cover plate kit:
Set the shutter (2) to the winter
N
position.
At temperatures above -10°C
Remove the parts of the cover plate
N
kit and refit the standard parts for
summer operation.
FS 360 C-M, FS 410 C-M, FS 460 C-M, FS 490 C-M
2
4
2
4