Stihl 410 C-M Instruction Manual page 30

English
Symbols on the choke lever
FS 490 FS 460
FS 360, 410, 460
Operating position F- in this position the
warm engine is started or the engine is
running.
Start } – in this position the cold engine
is started
Starting the engine
FS 360, 410, 460
4
FS 490
4
Press the manual fuel pump
N
bulb (4) at least five times - even
when bulb is filled with fuel
28
The choke lever is in the operating
positionF.
FS 360, 410, 460
5
FS 490
5
If the engine is cold: Press in the
N
choke lever (5) at the edge (arrows)
and turn to the start position }.
Starting
Place the machine on the ground in
N
a secure position: It must rest on the
hip plate on the engine and the
deflector for the cutting attachment.
The cutting attachment must not
touch the ground or any other
objects
Adopt a stable position - either
N
standing, bending over or kneeling
Press the machine firmly against the
N
ground with the left hand – do not
touch the throttle trigger or throttle
trigger lockout while doing so
NOTICE
Do not stand or kneel on the shaft!
Grab the starter grip with your right
N
hand
Pull the starter grip smoothly
N
NOTICE
Do not pull out the starter rope
completely – risk of breakage!
Do not let the starter grip snap back
N
– guide it slowly back into the
housing so that the starter rope can
rewind properly
Repeat this procedure until the
N
engine starts
If the engine still does not start: Turn
N
the choke lever to the start
position} and restart the tool.
FS 360 C-M, FS 410 C-M, FS 460 C-M, FS 490 C-M