Service - Graco 253017 Instructions-Parts List Manual

Replacing Wipers
1. To replace worn or damaged wipers (59 or 60),
raise the wiper plate up out of the drum. Remove
the drum from the base. Wipe the fluid off the
wiper plate.
2. Separate the wiper joint (A) and bend back the
strapping (65) covering the clamp setscrew (B).
See Detail A of Fig. 8. Loosen the setscrew, pull
the end of the strapping through the clamp (72)
and remove the wiper.
3. Slide the strapping (65) through the new wiper (59
or 60). Slide the clamp (72) onto the new strapping
and bend the strapping back approximately 3 in.
(76 mm). Insert the strapping through the clamp a
second time. See Detail B of Fig. 8.
4. Install the wipers on the wiper plate. Position the
wipers so that their joints (A) are 180_ apart.
Detail A
59 or 60
02949
Detail C
Slide the clamp onto the strapping and bend the
1
strapping back approximately 3 in. (76 mm).
Turn clockwise to apply tension.
2
3
Cut the strapping and bend it back over the clamp.
Fig. 8

Service

B
72 65
A
E
F
2
NOTE: You will need the special banding tool (C)
shown in Detail C of Fig. 8 to tighten the strapping.
See Accessories.
5. Grip the strapping (65) with the tool (C) as shown.
With your thumb on the gripper lever (E), turn the
tool handle (F) clockwise to apply tension.
NOTE: Be careful not to pull the cutting handle (D)
until you are ready to cut the strapping in step 7.
6. Continue turning the tool handle until you see the
strapping stop moving through the clamp (72).
Stop turning the handle.
7. Tighten the setscrew (B) with a wrench (G). Pull
the cutting handle (D) to cut. Remove the tool (C).
Bend the strapping back over the clamp (72).
8. Pound the wiper all the way around with a rubber
mallet until the joints (A) are butted tightly together.
Detail B
59 or 60
C
D
65
1
H 72 65
3
72
B
G
306934
02946
05712
13