Finish In Time - Bosch WAP28481AU Instruction Manual

Programme default settings
en
You can select "Rinse Stop" to prevent
creasing if the laundry will not be taken
out of the washing machine immediately
after the program has ended.
To continue/end the program
~ Page 20
The maximum speed that can be set
depends on the model and program
that has been selected.

Finish in time

(ñ Ready in//ñ Finished in)
Before starting the program, you can
preselect the program end ("Ready in"
time) in hourly increments (h = hour) up
to a maximum of 24 hours.
To do this:
Select a program.
1.
The program duration is displayed
for the selected program, e.g. 2:30
(hours:minutes).
Press the (ñ Ready in//ñ Finished
2.
in) button repeatedly until the
required number of hours is
displayed.
Press the A button.
3.
The door will be locked.
The selected number of hours
(e.g. 8 h) is shown in the display
panel and counts down until the
wash program starts. The duration of
the program is then displayed.
14
During the timer count-down, you can
change the preselected number of
hours as follows:
Press the A button.
1.
Use the (ñ Ready in//ñ Finished in)
2.
button to change the number of
hours.
Press the A button.
3.
During the timer count-down, you can
add or remove laundry as required:
Press the A button.
1.
Open the door and add or remove
2.
laundry.
Close the door.
3.
Press the A button.
4.
The length of the program is
Note:
automatically adjusted when the
program is running.
Certain factors can affect the program
length, e.g.:
Program settings,
■
Detergent dosage (additional rinse
■
cycles if required due to foaming),
Load size/type of textiles (longer
■
washing for higher load and for
textiles which absorb more water),
Imbalances (e. g. due to fitted
■
sheets) are offset with several start-
ups of spin cycles,
Fluctuations in power supply,
■
Water pressure (infeeding speed).
■