Table of Contents
Advertisement
Programme default settings
en
0
Programme default
settings
You can find possible
N ote:
P r o g r a m m e d e f a u l t s e t t i n g s
programme default settings in the
overview; these differ depending on the
model.
The programme default settings for all
programmes are preset at the factory
and are displayed in the display panel
after the programme is selected.
Temperature
(6 Temperature)
Setting depending on the model
Depending on what stage the program
is in, you can change the set
temperature before and at the
beginning of the program.
The maximum temperature that can be
set depends on the program that has
been selected.
Spin Speed
((0 rpm))
Depending on what stage the program
is in, you can change the spin speed (in
rpm; revolutions per minute) before and
during the program.
Setting 0: The rinsing water is drained
but there is no final spin. The laundry
stays wet inside the drum, e.g. for items
that should not be spun.
Setting - - - -: (Rinse Stop) = no final
spin. The laundry stays in the water after
the final rinse.
You can select "Rinse Stop" to prevent
creasing if the laundry will not be taken
out of the washing machine immediately
after the program has ended.
30
To continue/end the program
~ Page 36
The maximum speed that can be set
depends on the model and program
that has been selected.
Finish in time
(ñ Finished In)
Before starting the program, you can
preselect the program end ("Ready in"
time) in hourly increments (h = hour) up
to a maximum of 24 hours.
To do this:
Select a program.
1.
The program duration is displayed
for the selected program, e.g. 2:30
(hours:minutes).
Press the ñ Finished In button
2.
repeatedly until the required number
of hours is displayed.
Press the A Start/Reload button.
3.
The door will be locked.
The selected number of hours
(e.g. 8 h) is shown in the display
panel and counts down until the
wash program starts. The duration of
the program is then displayed.
During the timer count-down, you can
change the preselected number of
hours as follows:
Press the A Start/Reload button.
1.
Use the ñ Finished In button to
2.
change the number of hours.
Press the A Start/Reload button.
3.
During the timer count-down, you can
add or remove laundry as required:
Press the A Start/Reload button.
1.
Open the door and add or remove
2.
laundry.
Close the door.
3.
Press the A Start/Reload button.
4.
Advertisement
Table of Contents
